Skoda Octavia II 2004 Workshop Manual page 54

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
– Pull hydraulic unit with control unit upwards and out of the
rubber bearings in -direction of arrow-.
– Unscrew the bracket from the hydraulic unit.
Installing:
Note
Only remove plugs from the new hydraulic unit if the relevant
♦
brake line is installed.
If the plugs were already removed from the hydraulic unit, then
♦
brake fluid may escape and adequate filling and bleeding can
no longer be guaranteed.
– Screw the bracket onto the hydraulic unit and tighten to the
recommended tightening torque.
– Moisten the bolt of the support
cant, e.g. -D 007 000 A2- , before inserting into the rubber
bearings.
– Insert the hydraulic unit with the control unit into the rubber
bearings of the console against the -direction of arrow-.
– Remove the plugs consecutively from the brake lines and the
ABS hydraulic unit.
– Screw the marked brake lines onto the hydraulic unit.
48
Rep. gr.45 - Anti-lock brake system
⇒ Item 30 (page 44) with lubri‐
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�