Removing And Installing Brake Caliper, Floating Caliper Disc Brake Fs-Iii - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
1.4 Removing and installing brake caliper,
floating caliper disc brake FS-III
Special tools and workshop equipment required
♦ Brake pedal load e.g. -V.A.G 1869/2-
Removing:
This procedure applies only to exchanging or the following repair
work on the brake caliper.
– Remove wheels.
– Disconnect the connector for the brake pad wear indicator.
– Attach the bleeder hose of the bleeding bottle onto the vent
valve of the brake caliper and then open then bleeder valve.
– Position brake pedal load , e.g. -V.A.G 1869/2- .
– Close the vent valve and remove the bleeding bottle.
– Unscrew brake hose.
– Remove both caps out of the bushings of the brake caliper.
– Loosen and remove the two guide bolts from the brake caliper.
– Remove brake caliper from brake carrier
– Take out the brake pads from the brake caliper.
Installing:
• The piston is pushed back.
– Insert inside brake pad (piston side) -1- and outside brake pad
-2- with retaining springs into the brake caliper.
♦ Inside brake pad (piston side) with large 3-finger clip -1-.
♦ Outside brake pad with small 3-finger clip -2- (black in colour).
– First, position the brake caliper with the brake pads at the bot‐
tom -arrow- of the brake carrier.
100
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�