Removing And Installing The Hand-Brake Cable - Skoda Octavia II 2004 Workshop Manual

– Tighten adjusting nut -arrow-, ...
– ... So that the levers -1- rise from the stop -2- on the brake
calipers.
– The distance -a- to the stop -2- on the left and right brake cal‐
iper must together not exceed 1.5 mm.
– Check whether both wheels rotate freely.
Once reset, no resetting of the hand brake is necessary due to
automaticy adjustment of the brakes on the rear wheels.
3.3 Removing and installing the hand-brake
cable
Removing:
– Put hand-brake back.
– Remove the centre console ⇒ Body Work; Rep. gr. 68 .
– Release the adjusting nut -1- so far until the respective hand-
brake cable -2- can be unhooked from the compensating
clamp -3-.
For the version with the spring clip
– Lever off spring clip -1-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
133
3. Handbrake