Repairing The Brake Caliper Bosch Biriii - Skoda Octavia II 2004 Workshop Manual

To do so hold the piston in front of the brake caliper.
Caution
Use the resetting tool - T10165- to adjust the piston.
The automatic adjustment in the brake caliper is destroyed
when adjusting the piston with a resetting tool e.g. -T10165- or
by actuating the brake pedal.
Insert the resetting tool - T10165- in such a way that the collar is
resting on the brake caliper.
– Screw the piston by turning the knurled wheel of the resetting
tool - T10165- to the right into the brake caliper.
2.4

Repairing the brake caliper Bosch BIRIII

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Note
Brake inspection ⇒ page 8
♦
Install the complete repair set when undertaklng repairs.
♦
Use only methylated spirits for cleaning the brake.
♦
Thinly coat brake cylinder, piston and gasket ring with lithium grease - G 052 150 A2- .
♦
The brake calipers must absolutely be pre-bled before installing them in the vehicle (without brake pads) in
♦
case of a repair or when replacing them with new brake calipers
.
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
⇒ page 166 .
2. Repairing rear brake caliper
163