Removing And Installing The Brake Caliper Piston Bosch Biriii - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
1 - Brake caliper with lever for
the handbrake cable
❑ replace brake caliper if
the lever for the hand‐
brake cable is not
sealed
❑ pre-bleed brake caliper
after undertaking re‐
placement ⇒ page 166
2 - Dust cap
3 - Vent valve, 10 Nm
❑ thinly coat thread with
lithium grease -
G 052 150 A2- before
screwing in
4 - Self-locking screw, 35 Nm
❑ Replacing
❑ counterhold on the
guide bolt when releas‐
ing and tightening
5 - Guide bolt
❑ grease before fitting
protective cap
6 - Boot
❑ pull onto brake carrier
and guide bolt
7 - Brake carrier with guide
bolts and boots
❑ must be assembled with
sufficient grease on the
guide bolt, supplied as a
spare part
❑ fit a repair set if there is
any damage to the pro‐
tective caps or guide bolts, use the enclosed grease packing to lubricate the guide bolts
❑ Assignment ⇒ Electronic Catalogue of Original Parts
8 - Boot
❑ pull with inner sealing lip onto the piston
❑ Removing and installing
9 - Piston with automatic adjusting device
❑ Removing and installing
❑ thinly coat piston with assembly paste - G 052 150 A2- before fitting
10 - Sealing ring
❑ Removing and installing
2.5 Removing and installing the brake cali‐
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
per piston Bosch BIRIII
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Special tools and workshop equipment required
♦ Resetting tool - T10165-
♦ Disassembly wedge - 3409-
164
Rep. gr.47 - Brakes - hydraulics
⇒ page 164
⇒ page 164
⇒ page 164