Repairing Brake Caliper Ci 38 - Skoda Octavia II 2004 Workshop Manual

11 - Sealing ring
❑ Removing and installing
2.2

Repairing brake caliper CI 38

Note
Brake inspection ⇒ page 8
♦
Install the complete repair set when undertaklng repairs.
♦
Use only methylated spirits for cleaning the brake.
♦
Thinly coat brake cylinder, piston and gasket ring with lithium grease - G 052 150 A2- .
♦
The brake calipers must absolutely be pre-bled before installing them in the vehicle (without brake pads) in
♦
case of a repair or when replacing them with new brake calipers
1 - Brake caliper with lever for
the handbrake cable
❑ replace brake caliper if
the lever for the hand‐
brake cable is not
sealed
❑ pre-bleed brake caliper
after undertaking re‐
placement ⇒ page 166
2 - Dust cap
3 - Vent valve, 10 Nm
❑ thinly coat thread with
lithium grease -
G 052 150 A2- before
screwing in
4 - Self-locking screw, 35 Nm
❑ replace after each re‐
moval
❑ counterhold on the
guide bolt when releas‐
ing and tightening
5 - Guide bolt
❑ grease before fitting
protective cap
6 - Boot
❑ pull onto brake carrier
and guide bolt
7 - Brake carrier with guide
bolts and boots
❑ must be assembled with
sufficient grease on the
guide bolt, supplied as a
spare part
❑ fit a repair set if there is
any damage to the protective caps or guide bolts, use the enclosed grease packing to lubricate the guide
bolts
8 - Boot
❑ pull with outer sealing lip onto the piston
⇒ page 162
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
⇒ page 166 .
2. Repairing rear brake caliper
161