Summary Of Components Abs Mark 60 Ec - For Left-Hand Drive As Of My 2009 - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
6.2 Summary of components ABS Mark 60 EC - for left-hand drive as of MY
2009
Note
Vehicles up to CW 21/2008 are fitted with the control unit for ABS Mark 60.
♦
Vehicles up to CW 22/2008 are fitted with the control unit for ABS Mark 60 EC. A sensor unit for ESP (ESC)
♦
-G419- is integrated in this control unit. Depending on the equipment, the control unit for ABS Mark 60 EC
must not be fitted with these senders on vehicles with front-wheel drive.
If the ABS hydraulic unit - N55- is damaged, the ABS control unit - J104- must be fully replaced with the
♦
ABS hydraulic unit - N55- .
The ABS control unit - J104- can be separated from the ABS hydraulic unit - N55-
♦
The hydraulic pump and the ABS hydraulic unit - N55- must not be separated from each other.
♦
1 - ABS control unit - J104-
❑ with ABS hydraulic unit -
N55-
❑ with integrated sensor
unit for ESP (ESC) -
G419-
❑ The ABS control unit -
J104- and the ABS hy‐
draulic unit - N55- must
not be separated from
each other
❑ Removing and installing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
⇒ page 67
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
❑ Disconnecting the con‐
trol unit from the hy‐
draulic unit ⇒ page 72
❑ Fitting the control unit to
the hydraulic unit
⇒ page 73
2 - Brake line, 14 Nm
❑ from master brake cylin‐
der (push rod piston cir‐
cuit) to hydraulic unit
❑ Distinguishing feature:
∅ 6.5 mm and pipe
screw with long thread
M12 x 1
3 - Brake line, 14 Nm
❑ from master brake cylin‐
der (floating piston cir‐
cuit) to ABS hydraulic
unit
❑ Distinguishing feature:
∅ 6.5 mm and pipe
screw with long thread
M12 x 1
4 - Brake line, 14 Nm
❑ to front left brake caliper
❑ Distinguishing feature: ∅ 5.25 mm and pipe screw with short thread M10 x 1
5 - Brake line, 14 Nm
❑ To front right brake caliper.
64
⇒ page 72 .