Removing And Installing The Brake Caliper Piston Cii 41 Or Ci 38 - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
❑ Removing and installing
9 - Piston with automatic adjusting device
❑ Removing and installing
❑ thinly coat piston with assembly paste - G 052 150 A2- before fitting
10 - Sealing ring
❑ Removing and installing
2.3 Removing and installing the brake cali‐
per piston CII 41 or CI 38
Special tools and workshop equipment required
♦ Resetting tool - T10165-
♦ Disassembly wedge - 3409-
Removing:
Insert the resetting tool - T10165- in such a way that the collar is
resting on the piston.
– Release the piston by turning the knurled wheel of the reset‐
ting tool - T10165- to the left.
♦ Use open-jawed spanner on a provided spanner surface
-arrow A- if the piston is difficult to move.
– Remove gasket ring with disassembly wedge - 3409- .
Installing:
– Clean piston and gasket ring with white spirits and dry off.
– Before installing the piston and gasket ring thinly coat with
lithium grease - G 052 150 A2- .
– Position the protective cap with the outer sealing lip on the
piston.
– Insert inner sealing lip of the protective cap with disassembly
wedge - 3409- in the groove of the cylinder.
162
Rep. gr.47 - Brakes - hydraulics
⇒ page 162
⇒ page 162
⇒ page 162
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�