Repairing Front Wheel Brake, Brake Caliper Fn3 - Skoda Octavia II 2004 Workshop Manual

1.5

Repairing front wheel brake, brake caliper FN3

Note
Observe the instructions for changing the pad
♦
Brake inspection ⇒ page 8
♦
After replacing the brake pads, depress brake pedal firmly several times when the vehicle is stationary to
♦
ensure the brake pads are properly seated in their normal operating position.
Use the brake filling and bleeding device , e.g. -VAS 5234- , to drain the brake fluid from the brake fluid
♦
reservoir.
Use brake pedal loader , e.g. -V.A.G 1869/2- before removing a brake caliper or separating a brake hose
♦
from the brake caliper
1 - Screw, 4 Nm
2 - Brake disc
❑ internally ventilated
❑ Assignment, dimen‐
sions and wear limit
⇒ page 1
❑ always replace axle-
wise
❑ unscrew the brake cali‐
per before removing
3 - Brake pads
❑ Assignment, dimen‐
sions and wear limit
⇒ page 1
❑ with wear indicator (on
the left side of the vehi‐
cle)
❑ if worn (pad thickness
without supporting plate
approx 4 mm) the brake
pad warning light - K32-
lights up in the dash
panel insert
❑ always replace axle-
wise
❑ Removing and installing
⇒ page 104
❑ Observe the instruc‐
tions for changing the
pad ⇒ page 94
4 - Spring
❑ inserted into both bore
holes of the brake cali‐
per
5 - Brake carrier
❑ screwed onto the wheel-bearing housing
6 - Brake caliper
❑ Observe the instructions for changing the pad
❑ do not unscrew the brake hose when replacing the brake pad
❑ Removing and installing
⇒ page 94
⇒ page 94
⇒ page 108
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
103