Removing And Installing Brake Pads Bosch Biriii - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
10 - Wheel hub with wheel bearing (vehicles with four-wheel drive)
❑ Assignment ⇒ Electronic Catalogue of Original parts
11 - Tighten screw 70 Nm + 90° (vehicles with four-wheel drive)
❑ replace after each removal
❑ removing and installing ⇒ chassis, axles, steering; Rep. gr. 42
12 - Brake disc
❑ Assignment, dimensions and wear limit
❑ if worn replace axle-wise
❑ unscrew the brake caliper before removing
❑ Assignment ⇒ Electronic Catalogue of Original Parts
13 - Screw, 4 Nm
14 - Brake pads
❑ Assignment, dimensions and wear limit
❑ always replace axle-wise
❑ Removing and installing
❑ Observe the instructions for changing the pad
15 - Brake carrier with guide bolts and boots
❑ must be assembled with sufficient grease on the guide bolt, supplied as a spare part
❑ fit a repair set if there is any damage to the protective caps or guide bolts, use the enclosed grease
packing to lubricate the guide bolts
❑ Assignment ⇒ Electronic Catalogue of Original Parts
16 - Pad retaining plate
❑ always replace when changing the brake pads
17 - Brake caliper
❑ Observe the instructions for changing the pad
❑ do not unscrew the brake hose when replacing the brake pad
❑ Removing and installing
❑ repairing ⇒ page 163
❑ One must first adjust the hand-brake cable after undertaking repair or replacement work
❑ Setting the hand-brake
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
18 - Self-locking screw, 35 Nm unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
❑ replace after each removal
19 - Hand-brake cable
❑ Setting the hand-brake
20 - Retaining clip for brake line
21 - Brake hose with banjo union and hollow screw, 35 Nm
22 - Wheel-bearing housing (vehicles with four-wheel drive)
❑ Assignment ⇒ Electronic Catalogue of Original parts
23 - Screw, 90 Nm + 90°
❑ replace after each removal
2.9 Removing and installing brake pads
Bosch BIRIII
Special tools and workshop equipment required
♦ Resetting tool - T10165-
126
⇒ page 1
⇒ page 1
⇒ page 126
⇒ page 111
⇒ page 111
⇒ page 130
⇒ page 132
⇒ page 132