Skoda Octavia II 2004 Workshop Manual page 75

– Mark both brake lines from the master brake cylinder -A- and
-B- and unscrew from the hydraulic unit.
– Close the brake lines and threaded holes immediately with
plugs from the repair kit -1H0 698 311 A- .
– Mark the brake lines (for brake caliper) -1- to -4-, unscrew and
close.
– Pull ABS hydraulic unit upwards and out of the rubber bear‐
ings.
WARNING
The hydraulic pump and the ABS hydraulic unit - N55- must
not be separated from each other.
Installing:
Note
Only remove plugs from the new hydraulic unit if the relevant
♦
brake line is installed.
If the plugs were already removed from the hydraulic unit, then
♦
brake fluid may escape and adequate filling and bleeding can
no longer be guaranteed.
Screw the bracket for the ABS control unit onto the ABS control
unit and tighten to the recommended tightening torque.
Moisten the bolt of the support
e.g. -D 007 000 A2- , before inserting into the rubber bearings.
Insert the ABS control unit with bracket into the rubber bearings
of the console.
WARNING
Make sure that the rubber bearings are not pressed out of the
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
console when installing the bracket. After installing, check the
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
ABS control unit for tight fit, otherwise failure may be caused
by a malfunctioning.
6. Hydraulic control unit, brake servo unit/master brake cylinder ABS Mark 60/Mark 60 EC (ABS/EDL/TCS/ESP (ESC))
⇒ Item 29 (page 66) with lubricant,
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
69