Removing And Installing The Pressure Sensor For The Brake Servo Unit G294 - Skoda Octavia II 2004 Workshop Manual

5.8 Removing and installing the pressure
sensor for the brake servo unit -G294-
Removing:
– Disconnect the plug from the pressure sensor for the brake
servo unit -G294- .
– Pull the vacuum line with the pressure sensor for the brake
servo unit -G294- out of the brake servo unit.
– Unlatch clamps -1- e.g. with pliers.
– Carefully lever off the pressure sensor for the brake servo unit
-G294- -2- from the vacuum line.
Installing:
Installation is carried out in the reverse order.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
185