Skoda Octavia II 2004 Workshop Manual page 203

– Unscrew the screws -1- of the brake servo unit and remove.
Vehicles with diesel engines TDI CR
– Remove cover for timing belt.
– Attach the engine on the right to the supporting device -
T30099- .
– Partially lower the engine on the right vehicle side by approx.
60 to 70 mm ⇒ Engine; Rep. gr. 10 or ⇒ Engine; Rep. gr.
13 , while doing so pay attention to all the lines.
– Slightly pull the engine towards the front with the assistance
of a second mechanic.
– Swivel the brake servo unit with a pressure rod via the cam‐
shaft belt pulley.
Vehicles with diesel engines TDI PD
– Swivel the brake servo unit in the space above the exhaust
gas turbocharger.
– Slightly tilt the engine forward.
Continued for all vehicles
– Remove the brake servo unit from the vehicle.
Installing:
– Installation is carried out in the reverse order.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
Note
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
If the battery earth strap is disconnected and connected, carry out
certain additional operations ⇒ Electrical System; Rep. gr. 27 .
After installing, it is necessary to:
– Bleed brake system
– Bleed clutch ⇒ Gearbox; Rep. gr. 30 .
Vehicles up to 11/2005
– Setting the brake light switch
⇒ page 168 .
⇒ page 149 .
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
197