Connecting The Brake Lines From The Master Brake Cylinder To The Hydraulic Unit - Right-Hand Drive - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
5 - Brake line, 14 Nm
❑ to front left brake caliper
❑ Distinguishing feature for vehicles up to CW 21/2008: pipe screw with thread M12 x 1
❑ Distinguishing feature for vehicles as of CW 22/2008: pipe screw with thread M10 x 1
6 - ABS control unit - J104-
❑ Removing and installing
❑ Disconnecting the control unit from the hydraulic unit
❑ Fitting the control unit to the hydraulic unit
7 - Screw, 5.5 Nm
8 - ABS hydraulic unit - N55-
❑ Removing and installing
9 - Mounting bracket
– Moisten the bolt of the support with lubricant, e.g. -D 007 000 A2- , before inserting into the rubber
bearings
❑ after installing, check for firm seating
10 - Rubber bearing
❑ make sure that the rubber bearings are not pressed out of the console when installing the bracket
11 - Console
❑ before installing the rubber bearings
lubricant, e.g. -D 007 000 A2-
12 - Nut, 20 Nm
13 - Screw, 8 Nm
14 - Brake line, 14 Nm
❑ to rear left brake caliper
❑ Distinguishing feature: pipe screw with thread M12 x 1
15 - Brake line, 14 Nm
❑ to rear right brake caliper
❑ Distinguishing feature: Pipe screw with thread M10 x 1
5.7 Connecting the brake lines from the
master brake cylinder to the hydraulic
unit - right-hand drive
Connect brake lines to the master brake cylinder
A - from master brake cylinder (push rod piston circuit) to ABS
hydraulic unit
- Distinguishing feature for vehicles up to CW 21/2008: pipe screw
with thread M10 x 1
- Distinguishing feature for vehicles as of CW 22/2008: pipe screw
with thread M12 x 1
B - from master brake cylinder (floating piston circuit) to ABS hy‐
draulic unit
- Distinguishing feature: pipe screw with thread M12 x 1
4 - Hydraulic unit to front right brake caliper
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
54
⇒ page 55
⇒ page 60
⇒ page 55
⇒ Item 10 (page 54)
⇒ page 59
, moisten the holes for rubber bearings with