Skoda Octavia II 2004 Workshop Manual page 95

– Separate plug connection -1- of ABS speed sensor/wheel
speed sensor cable.
– Release screw -2- from the wheel-bearing housing.
– Take the ABS-speed sensor out of the wheel bearing housing.
Installing:
– Clean the inner surface of the hole before inserting the ABS
speed sensor and brush over the ABS speed sensor with a hot
screw paste - G 052 112 A3- .
– Insert the ABS speed sensor in the bore of the wheel-bearing
housing and tighten the screw.
– Connect the plug connection on the ABS speed sensor.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
89