Skoda Octavia II 2004 Workshop Manual page 171

Removing:
Insert the resetting tool - T10165- in such a way that the collar is
resting on the piston.
– Release the piston by turning the knurled wheel of the reset‐
ting tool - T10165- to the left.
♦ Use open-jawed spanner on a provided spanner surface
-arrow A- if the piston is difficult to move.
– Remove protective cap and gasket ring with disassembly
wedge - 3409- .
Installing:
– Clean piston and gasket ring with white spirits and dry off.
– Before installing the piston and gasket ring thinly coat with
lithium grease - G 052 150 A2- .
– Position the new protective cap with the inner sealing lip on
the piston.
– Insert outer sealing lip of the protective cap with the disas‐
sembly wedge - 3409- in the shoulder on the brake caliper.
– Carefully press on the protective cap up to the stop using the
disassembly wedge - 3409- .
Note
Pay attention to the correct position of the protective cap in the
♦
brake caliper.
Do not damage the protective cap when pressing it on.
♦
Caution
Use the resetting tool - T10165- to adjust the piston.
The automatic adjustment in the brake caliper is destroyed
when adjusting the piston with a resetting tool e.g. -T10165- or
by actuating the brake pedal.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
2. Repairing rear brake caliper
165