Removing And Installing Brake Servo Unit - Right-Hand Drive - Skoda Octavia II 2004 Workshop Manual

7.3 Removing and installing brake servo
unit - right-hand drive
Special tools and workshop equipment required
♦ Brake filling and bleeding device , e. g. -VAS 5234-
♦ Screw plug set for engine - VAS 6122/40-
♦ Supporting device - T30099-
♦ Supporting plate - T30099/1-
♦ Hook - MP9–200/3-
Removing:
– Removing driver side trim panel ⇒ Body Work; Rep. gr. 70 .
Vehicles up to 11/2005
– Unplug connector -1- from the brake light switch (if present).
– Remove brake light switch -2- (if present) by turning 45° to the
left.
Continued for all vehicles
– Separating the brake pedal from the brake servo unit
⇒ page 145 .
Octavia II 2004 ➤ , Octavia II 2010 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Brake systems - Edition 11.2017
195