Removing And Installing Brake Caliper Bosch Biriii - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
2.10 Removing and installing brake caliper
Bosch BIRIII
Special tools and workshop equipment required
♦ Brake pedal load , e.g. -V.A.G 1869/2-
Removing:
This procedure applies only to exchanging or the following repair
work on the brake caliper.
– Remove wheels.
– Detach the hand brake cable from the lever on the brake cal‐
iper.
– Remove spring clip and pull hand brake cable out of the brake
caliper holder.
– Attach the bleeder hose of the bleeding bottle onto the vent
valve of the brake caliper and open bleeder valve.
– Brake pedal load e.g. -V.A.G 1869/2-
– Close the vent valve and remove the bleeding bottle.
– Unscrew brake hose.
– Unscrew the fixing screws of the brake carrier while counter‐
holding the guide bolts.
– Remove brake caliper from brake carrier
Installing:
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
• The piston is pushed back.
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
• The brake pads are fitted in the retaining springs on the brake
caliper.
– Secure the brake caliper to the brake carrier using new self-
locking screws.
– Bolt brake hose to brake caliper.
– Bleed brake system
– Install the hand brake cable and attach with spring clips to the
support.
– Adjust handbrake ⇒ page 132
– Attach the wheels.
Note
Observe the instructions for changing the pad
♦
Firmly depress brake pedal several times with vehicle station‐
♦
ary so that the brake pads are properly seated in their normal
operating position.
Check brake fluid level.
♦
130
⇒ page 168 .
.
⇒ page 111