Removing And Installing Piston Of Brake Caliper Fn3 - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
1 - Cover caps
❑ insert in bushing
2 - Guide bolt, 30 Nm
3 - Bushing
❑ insert into the brake cal‐
iper housing
4 - Dust cap
❑ place on the vent valve
5 - Vent valve, 10 Nm
❑ thinly coat thread with
lithium grease -
G 052 150 A2- before
screwing in
6 - Brake caliper
7 - Brake carrier
❑ crewed to the brake cal‐
iper
8 - Spring
❑ insert with both ends in‐
to the bores in the brake
caliper
9 - Sealing ring
❑ Removing and installing
⇒ page 156
10 - Piston
❑ Removing and installing
⇒ page 156
❑ First thinly coat piston
with lithium grease -
G 052 150 A2-
11 - Boot
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
❑ Removing and installing
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
❑ do not damage when inserting the piston
1.4 Removing and installing piston of brake
caliper FN3
Special tools and workshop equipment required
♦ Disassembly wedge - 3409-
♦ Piston jig - T10145-
♦ Assembly tool - T10146/6-
Removing:
– Press the piston out of the brake caliper using compressed air.
156
Rep. gr.47 - Brakes - hydraulics
⇒ page 156