Skoda Octavia II 2004 Workshop Manual page 84

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
– Release the plug at the ABS control unit
-in direction of arrow 1-.
– Disconnect the plug from the control unit in
-direction of arrow 2-.
– Release screw -3-.
– Pull the ABS control unit with bracket out of the rubber bear‐
ings in the console in -direction of arrow 2-.
– Remove the ABS control unit and unscrew the bracket from
the ABS control unit.
Note
If the rubber bearings are pulled out of the console at the same
time, place the bearings in the same position again
⇒ Item 9 (page 75) .
WARNING
The hydraulic pump and the ABS hydraulic unit - N55- must
not be separated from each other.
Installing
Note
Only remove plugs from the new hydraulic unit if the relevant
♦
brake line is installed.
If the plugs were already removed from the hydraulic unit, then
♦
brake fluid may escape and adequate filling and bleeding can
no longer be guaranteed.
– Screw the bracket for the ABS control unit onto the ABS control
unit and tighten to the recommended tightening torque.
– Moisten the bolt of the support
cant, e.g. -D 007 000 A2- , before inserting into the rubber
bearings.
– Insert the ABS control unit with bracket into the rubber bear‐
ings of the console.
WARNING
Make sure that the rubber bearings are not pressed out of the
console when installing the bracket. After installing, check the
ABS control unit for tight fit, otherwise failure may be caused
by a malfunctioning.
78
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ Item 12 (page 75) with lubri‐