Removing And Installing Brake Pads Cii 41 - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
21 - Hose clamp
22 - Brake line, 14 Nm
23 - Hand-brake cable
❑ Setting the hand-brake
24 - Self-locking screw, 35 Nm
❑ replace after each removal
25 - Spring strap clamp
❑ only fitted on certain versions
26 - Brake hose
2.3 Removing and installing brake pads CII
41
Special tools and workshop equipment required
♦ Resetting tool - T10165-
Removing:
When removing mark the brake pads you intend to keep using.
Fit in same position when installing, or braking will be uneven!
– Remove wheels.
– Unscrew the fixing screws of the brake carrier while counter‐
holding the guide bolts.
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
– Remove the brake caliper and e.g. secure with wire in such a
way that the weight of the brake caliper does not burden or
damage the brake hose.
– Remove the brake pads and pad retaining plates -arrows-.
Installing:
Drain the brake fluid from the brake fluid reservoir using a venti‐
lation bottle before resetting the piston. Otherwise, particularly if
reservoir has been topped up, fluid will overflow and cause dam‐
age.
114
⇒ page 132
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�