– Screw in the piston by turning the knurled wheel clockwise on
the resetting tool - T10165- , during this procedure do not
damage the protective cap.
– To insert use the special tool -T10165/1- .
♦ Use open-jawed spanner on a provided spanner surface
-arrow A- if the piston is difficult to move.
– Insert the new pad retaining plates -arrows- and brake pads
in the brake carrier.
– Make sure that the brake pads are located in the pad retaining
plates -arrows-.
– Secure the brake caliper using new self-locking screws.
♦ There are four self-locking screws in the repair set, which must
be fitted.
– Attach the wheels.
Note
Observe the instructions for changing the pad
♦
After each brake pad replacement, forcefully apply the brake
♦
pedal repeatedly to ensure the brake pads go into their normal
operating position.
Check brake fluid level after changing brake pads.
♦
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
⇒ page 111
115
2. Repairing rear brake