Removing And Installing Brake Pedal - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
For all vehicles
– Press the brake pedal towards the brake servo unit and hold
it in position.
– Insert release tool - T10159A- and pull it in the direction of the
driver's seat while counterholding the brake pedal (the pedal
must not move backwards during this operation). This pushes
the retaining lugs -3- of the mount off the ball head of the push
rod -2-.
The figure shows the separation of the brake pedal from the brake
servo unit with the foot controls removed for clarity.
– Pull release tool - T10159A- and brake pedal together towards
driver seat. (This causes the brake pedal to be drawn off the
ball head of the push rod).
Clipping:
– Hold ball head of push rod in front of mount and push brake
pedal in direction of brake servo, so that the ball head clicks
into place.
Further installation occurs in reverse order.
– Setting the brake light switch
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
5.3

Removing and installing brake pedal

Removing
– Separating the brake pedal from the brake servo unit
⇒ page 145 .
– Unscrew the nut -1-, while doing so counterhold the screw of
the brake pedal -4-.
– Remove the screw of the brake pedal -4- towards the left.
– Take the brake pedal -3- out of the bearing bracket -2-.
Installing
146
⇒ page 138 .
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�