Skoda Octavia II 2004 Workshop Manual page 166

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
1 - Brake caliper with lever for
the handbrake cable
❑ replace brake caliper if
the lever for the hand‐
brake cable is not
sealed
❑ pre-bleed brake caliper
after undertaking re‐
placement ⇒ page 166
2 - Dust cap
3 - Vent valve, 10 Nm
❑ thinly coat thread with
lithium grease -
G 052 150 A2- before
screwing in
4 - Self-locking screw, 35 Nm
❑ Replacing
❑ counterhold on the
guide bolt when releas‐
ing and tightening
5 - Guide bolt
❑ grease before fitting
protective cap
6 - Boot
❑ pull onto brake carrier
and guide bolt
7 - Brake carrier with guide
bolts and boots
❑ must be assembled with
sufficient grease on the
guide bolt, supplied as a
spare part
❑ fit a repair set if there is
any damage to the pro‐
tective caps or guide bolts, use the enclosed grease packing to lubricate the guide bolts
❑ Assignment ⇒ Electronic Catalogue of Original Parts
8 - Brake carrier with guide bolts and boots
❑ must be assembled with sufficient grease on the guide bolt, supplied as a spare part
❑ fit a repair set if there is any damage to the protective caps or guide bolts, use the enclosed grease
packing to lubricate the guide bolts
Note
When installing make sure that the
weight points downwards.
❑ Assignment ⇒ Electronic Catalogue of Original parts
9 - Boot
❑ pull with outer sealing lip onto the piston
❑ Removing and installing
10 - Piston with automatic adjusting device
❑ Removing and installing
❑ thinly coat piston with assembly paste - G 052 150 A2- before fitting
160
Rep. gr.47 - Brakes - hydraulics
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 162
⇒ page 162