Skoda Octavia II 2004 Workshop Manual page 68

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
1 - ABS control unit - J104-
❑ with ABS hydraulic unit -
N55-
❑ The ABS control unit -
J104- and the ABS hy‐
draulic unit - N55- must
not be separated on ve‐
hicles with brake assis‐
tance or on vehicles as
of CW 22/2008
❑ Removing and installing
⇒ page 67
❑ Disconnecting the con‐
trol unit from the hy‐
draulic unit ⇒ page 72
❑ Fitting the control unit to
the hydraulic unit
⇒ page 73
2 - Brake line, 14 Nm
❑ from master brake cylin‐
der (push rod piston cir‐
cuit) to ABS hydraulic
unit
❑ Distinguishing feature:
∅ 6.5 mm and pipe
screw with long thread
M12 x 1
3 - Brake line, 14 Nm
❑ from master brake cylin‐
der (floating piston cir‐
cuit) to ABS hydraulic
unit
❑ Distinguishing feature:
∅ 6.5 mm and pipe
screw with long thread
M12 x 1
4 - Brake line, 14 Nm
❑ to front left brake caliper
❑ Distinguishing feature: ∅ 5.25 mm and pipe screw with short thread M12 x 1
5 - Brake line, 14 Nm
❑ To front right brake caliper.
❑ Distinguishing feature: ∅ 5,25 mm and pipe screw with thread M10 x 1
6 - Brake line, 14 Nm
❑ to rear left brake caliper
❑ Distinguishing feature: ∅ 5.25 mm and pipe screw with short thread M12 x 1
7 - Brake line, 14 Nm
❑ to rear right brake caliper
❑ Distinguishing feature: ∅ 5,25 mm and pipe screw with thread M10 x 1
8 - Dummy plug
9 - Pressure sensor for the brake servo unit -G294-
❑ only on vehicles with petrol engines with brake vacuum pump
❑ Removing and installing
❑ Check ⇒ Vehicle diagnostic tester
10 - Vacuum line
❑ with non-return valve
62
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 185