Attaching Control Unit To Hydraulic Unit - Left-Hand Drive; Summary Of Components Abs Mark 60 Ec (Abs/Edl/Tcs/Esp) - Right-Hand Drive - Skoda Octavia II 2004 Workshop Manual

6.6 Attaching control unit to hydraulic unit -
Left-hand drive
WARNING
Strong vibrations (e.g. fall, knock) can destroy the control unit.
The control unit must no longer be used.
• The surfaces must be cleaned before assembling.
– Push all the gasket rings -A- a little over the valve domes.
– Position the control unit without tilting it onto the hydraulic unit.
Thus the gasket rings are brought into their end position.
– Screw hydraulic unit and control unit with the enclosed new
screws.
Note
A new control unit may only be installed on the same hydraulic
♦
unit twice as a maximum to ensure that the elastic seal is still
leak-tight.
A control unit, which was once operational, must not be moun‐
♦
ted a second time.
Specified torques:
Control unit to hydraulic unit 2 Nm + 0.8 Nm
6.7 Summary of components ABS Mark 60 EC (ABS/EDL/TCS/ESP) - right-
hand drive
Note
If the ABS hydraulic unit - N55- is damaged, the ABS control unit - J104- must be fully replaced with the
♦
ABS hydraulic unit - N55- .
The ABS control unit - J104- can be separated from the ABS hydraulic unit - N55-
♦
The hydraulic pump and the ABS hydraulic unit - N55- must not be separated from each other.
♦
Octavia II 2004 ➤ , Octavia II 2010 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Brake systems - Edition 11.2017
⇒ page 79 .
73