Skoda Octavia II 2004 Workshop Manual page 127

– Screw in the piston by turning the knurled wheel clockwise on
the resetting tool - T10165- , during this procedure do not
damage the protective cap.
– To insert use the special tool -T10165/1- .
♦ Use open-jawed spanner on a provided spanner surface
-arrow A- if the piston is difficult to move.
– Remove the protective foils from the supporting plates of the
new brake pad.
– Insert the brake pads into the brake carrier.
When installing the brake caliper make sure that the brake pads
does not stick to the brake caliper before reaching its correct in‐
stalled position.
– Secure the brake caliper using new self-locking screws.
♦ There are four self-locking screws in the repair set, which must
be fitted.
– Attach the wheels.
Note
Observe the instructions for changing the pad
♦
Firmly depress brake pedal several times with vehicle station‐
♦
ary so that the brake pads are properly seated in their normal
operating position.
Check brake fluid level.
♦
⇒ page 111
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
121