Skoda Octavia II 2004 Workshop Manual page 193

– Unscrew the brake lines -1- at the master brake cylinder, close
the brake lines with the screw plugs from the repair kit - 1H0
698 311 A- .
– Unscrew nuts -2- from brake master cylinder.
– If present, remove the protection plate.
– Carefully remove brake master cylinder from brake servo.
Installing:
– Installation is carried out in the reverse order.
When installing, pay particular attention to the following points:
Note
If the battery earth strap is disconnected and connected, carry out
certain additional operations ⇒ Electrical System; Rep. gr. 27 .
– When installing the master brake cylinder with the brake servo
unit pay attention to the correct positioning of the pressure rod
in the master brake cylinder.
After installing, it is necessary to:
– Bleed brake system
– Bleed clutch ⇒ Gearbox; Rep. gr. 30 .
⇒ page 168 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
6. Master brake cylinder
187