Skoda Octavia II 2004 Workshop Manual page 209

– Turn the spindle in the flaring tool up to the stop.
– Turn back the spindle once again.
– Loosen the Allan screws crosswise.
– Take the brake line out of the flaring tool, clean and check the
brake line as well as the flaring head.
Briefly flush the part of the brake line still in the vehicle:
– Connect brake filling and bleeding device , e. g. -VAS 5234- .
– Fit the hose of the bleeding bottle onto the flaring head of the
brake line and allow the brake filling and bleeding device e.g.
-VAS 5234- to run briefly, until some brake fluid has passed
through.
– Purge the brake line that you will be fitting with compressed
air.
– Assemble the brake lines together with the connecting piece
-E-.
– Install brake line.
– Bleed brake system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 168 .
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
203
8. Brake line