Skoda Octavia II 2004 Workshop Manual page 119

8 - ABS speed sensor (vehicles with four-wheel drive)
9 - Wheel hub with wheel bearing (vehicles with four-wheel drive)
10 - Screw (vehicles with four-wheel drive)
❑ Hexagon screw = 180 Nm + torque a further 180° ⇒ chassis, axles, steering; Rep. gr. 42
❑ Twelve-sided bolt = 70 Nm + torque a further 90° ⇒ chassis, axles, steering; Rep. gr. 42
❑ replace after each removal
11 - Screw, 12 Nm
❑ up to 05/2007 wheel bearing housing in steel casting and 3 screws
❑ as of 06/2007 aluminium wheel bearing housing and 4 screws
❑ Assignment ⇒ Electronic Catalogue of Original parts
12 - Wheel hub with wheel bearing (vehicles with front-wheel drive)
13 - Brake disc
❑ Assignment, dimensions and wear limit
❑ if worn replace axle-wise
❑ unscrew the brake caliper before removing
14 - Screw, 4 Nm
15 - Tighten screw 180 Nm + 180° (vehicles with front-wheel drive)
❑ replace after each removal
⇒ Chassis, axles, steering; Rep. gr. 42
16 - Brake pads
❑ Assignment, dimensions and wear limit
❑ always replace axle-wise
❑ Removing and installing
❑ Observe the instructions for changing the pad
17 - Brake carrier with guide bolts and boots
❑ must be assembled with sufficient grease on the guide bolt, supplied as a spare part
❑ fit a repair set if there is any damage to the protective caps or guide bolts, use the enclosed grease
packing to lubricate the guide bolts
Note
When installing make sure that the
weight points downwards.
❑ Assignment ⇒ Electronic Catalogue of Original parts
18 - Brake carrier with guide bolts and boots
❑ must be assembled with sufficient grease on the guide bolt, supplied as a spare part
❑ fit a repair set if there is any damage to the protective caps or guide bolts, use the enclosed grease
packing to lubricate the guide bolts
❑ Assignment ⇒ Electronic Catalogue of Original Parts
19 - Pad retaining plate
❑ always replace when changing the brake pads
20 - Brake caliper
❑ do not unscrew the brake hose when replacing the brake pad
❑ Removing and installing
❑ repairing ⇒ page 159
❑ One must first adjust the hand-brake cable after undertaking repair or replacement work
❑ Setting the hand-brake
❑ Observe the instructions for changing the pad
⇒ page 1
⇒ page 1
⇒ page 114
⇒ page 117
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 132
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
⇒ page 111
⇒ page 111
113
2. Repairing rear brake