Skoda Octavia II 2004 Workshop Manual page 76

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
– Connect the plug to the control unit against the
-direction of arrow 2- and lock.
– Remove the plugs consecutively from the brake lines and the
ABS control unit.
– Screw the marked brake lines onto the ABS control unit.
Diesel engines with the diesel particle filter:
– Install pre-exhaust pipe with diesel particle filter ⇒ diesel en‐
gine; Rep. gr. 26 .
1.9 ltr. diesel engine:
– Install intake manifold flap motor - V157- ⇒ Engine; Rep. gr.
23 (except vehicles with engine identification characters BJB).
– Install connecting hose to inlet connection ⇒ Engine; Rep. gr.
21 .
2.0 ltr. diesel engine:
– Install top toothed belt guard.
– Install connection pipe between intake hose and exhaust tur‐
bocharger.
– Install the bulkhead plenum chamber ⇒ Body Work; Rep. gr.
66 .
Continued for all vehicles:
– Install battery ⇒ Electrical System; Rep. gr. 27 .
Note
If the battery earth strap is disconnected and connected, carry out
certain additional operations ⇒ Electrical System; Rep. gr. 27 .
– Position engine cover.
– Remove brake pedal load e.g. -V.A.G 1869/2- .
– Bleed brake system
– Code the control unit - J104- ⇒ Vehicle diagnostic tester.
While doing so, a basic setting of the steering angle sender -
G85- , the lateral acceleration sender - G200- and of the brake
pressure sender 1 - G201- must be performed ⇒ Vehicle diag‐
nostic tester
70
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
⇒ page 168 .