Skoda Octavia II 2004 Workshop Manual page 38

Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
Warning light for tyre pressure display - K220-
♦ Warning light for tyre pressure inspection display - K220- -3-
comes on:
– Carry out tyre pressure inspection.
– Correct tyre pressure.
– Perform basic setting.
Initiating basic setting:
• Ignition on
– Press the button for tyre pressure inspection - E226- -arrow-
for more than 2 seconds.
When the button for tyre pressure inspection - E226- is pressed
the warning light for tyre pressure inspection display - K220- lights
up in the dash panel insert.
The basic setting is confirmed with an acoustic signal.
– Switch off ignition.
– After the ignition is switched on again, the warning light for tyre
pressure inspection display - K220- does no longer light up.
♦ Warning light for tyre pressure inspection display - K220-
flashes:
– Carry out tyre pressure inspection.
– Correct tyre pressure.
• Ignition on
– Press simultaneously the button for tyre pressure inspection -
E226- -arrow A- and the traction control system switch - E132-
or the TCS/ESP (ESC) button - E256- -arrow B- for more than
2 seconds.
Note
The traction control system switch - E256- may be installed in‐
stead of the TCS/ESP (ESC) button - E132- .
If the warning light for tyre pressure inspection display - K220-
continues to flash:
– Undertake "Targeted fault finding" ⇒ Vehicle diagnostic tester.
32
Rep. gr.45 - Anti-lock brake system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�