Fitting Position Of The Cap From The Brake Fluid Reservoir - Skoda Octavia II 2004 Workshop Manual

❑ Assignment ⇒ Electronic Catalogue of Original Parts
9 - Brake light switch -F- and brake pedal switch -F47-
❑ mounted as of 11.2005
❑ Fitting location: on master brake cylinder
❑ Removing and installing
❑ Check ⇒ Vehicle diagnostic tester
10 - Screw, 5 Nm
11 - Protection plate
❑ Assignment ⇒ Electronic Catalogue of Original Parts
12 - Foot controls
❑ different versions
❑ Assignment ⇒ Electronic Catalogue of Original parts
13 - Gasket
❑ Assignment ⇒ Electronic Catalogue of Original parts
14 - Screw, 25 Nm
❑ serves, at the same time, to secure the brake master cylinder and the brake servo unit.
15 - Nut, 50 Nm
❑ replace after each removal
16 - Brake line, 14 Nm
❑ Master brake cylinder/push rod piston circuit to hydraulic unit
17 - Screw, 3.5 Nm
5.3 Fitting position of the cap from the brake
fluid reservoir
The rig pin of the cap from the brake fluid reservoir must always
point to the recesses in the reservoir -arrow-.
I - Left-hand drive
II - Right-hand drive
⇒ page 149
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
5. Summary of Components: brake servo unit/master brake cylinder
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
177