Removing And Installing Bearing Bracket - Skoda Octavia II 2004 Workshop Manual

– Insert the brake pedal -3- into the bearing bracket -2-.
– Insert the screw of the brake pedal -4- from the left.
– Screw on the new nut -1- and tighten together with the screw
-4- ⇒ Item 5 (page 145)
– Clip the brake pedal onto the brake servo
Specified torques:
Brake pedal to bracket
♦ Use new nut!
5.4

Removing and installing bearing bracket

Removing
– Remove engine cover ⇒ Engine.; Rep. gr. 13
Vehicles with diesel engines TDI PD:
– Remove connecting hose to intake manifold flap ⇒ Engine;
Rep. gr. 21 .
– Slacken the fuel lines at the engine head ⇒ Relevant engine;
Rep. gr. 21 .
– Remove top cover for timing chain ⇒ Engine; Rep. gr. 13 .
Vehicles with diesel engines TDI CR:
– Remove filler neck for washer-fluid reservoir and lay it to one
side.
– Remove the coolant expansion bottle and lay it to one side.
– Slacken the fuel feed and fuel return line from the plastic clip.
– Separate the plug connection from the solenoid valve of the
diesel particle filter.
– Unscrew the bracket for the solenoid valve and lay it to one
side.
Continued for all vehicles:
– Remove brake pedal
– Unscrew the screws -1- of the brake servo unit -2-.
– Slacken the electrical lines from the pedal housing.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
.
⇒ page 145
⇒ page 146 .
Octavia II 2004 ➤ , Octavia II 2010 ➤
Brake systems - Edition 11.2017
.
25 Nm
5. Brake pedal - right-hand drive
147