Table of Contents
Advertisement
Replacing the Display—Part Number CTS-DISP-65-GEN4=
Route the power cable for the light fixture out through the hole in the top of the cabinet and through the
Note
rectangular slot at the rear of the display assembly.
Step 11
Attach the new light fixture to the assembly.
Route the cable for the new light fixture through the slot at the rear of the display assembly and the hole
Step 12
in the top of the cabinet.
Step 13
Connect the power cord for the new light fixture to the PDU in the cabinet.
Step 14
(Optional) using cable ties, tie the power cables together on the lower part of the light reflector.
Attach the light cover to the assembly.
Step 15
See
Mount the display to the display assembly.
Step 16
Reconnect the power and signal cords to the display.
Step 17
Replace the cabinet cover to the cabinet.
Step 18
Replace the bezel.
Step 19
See
Replace the speaker cover.
Step 20
See
Power on the system by turning the power switch on the PDU inside the cabinet to the "ON" position.
Step 21
Replace the cabinet cover.
Step 22
Replacing the Display—Part Number CTS-DISP-65-GEN4=
This procedure describes how to replace the display and includes the following sections:
•
•
Required Tools
A 3mm allen wrench is required to remove and reinstall the display mounting buttons.
Replacing the Display
To replace the display:
Step 1
Remove the speaker cover.
See
Cisco TelePresence System 1100 Assembly, First-Time Setup, and Field Replaceable Unit Guide
6-14
Figure 3-33
for more information.
Figure 3-38
for more information.
Figure 3-42
for more information.
Required Tools, page 6-5
Replacing the Display, page 6-14
Figure 3-42
for more information.
Chapter 6
Field-Replaceable Unit Guide
OL-19695-01
Hide quick links:
Advertisement
Table of Contents
