Replacing A Microphone (Mic) Bar-Part Number Cts-5K-Mic - Cisco TelePresence IX5000 Manual

Replacing a Microphone (Mic) Bar—Part Number CTS-5K-MIC=
Figure 6 Removing the Brackets from the Encoder/Decoder Codec
Step 6
Attach the brackets to the new codec.
Step 7
Insert the codec into the endpoint structure.
Step 8
Reconnect the cables.
Step 9
Disconnect the power to the switch and the table, and disconnect the Touch 10 devices. For more
information, refer to the
First-Time Setup
Step 10
Power on the PDUs.
Step 11
Attach the bottom fascia.
Step 12
Perform first-time setup of the system. For more information. refer to the
Setup
Replacing a Microphone (Mic) Bar—Part Number
CTS-5K-MIC=
Required Tools
#2 Phillips screwdriver
IX5000 Field-Replaceable Units and Country- and Region-Specific Power Connectors
40
"Preventing Touch 10 Configuration Issues"
document.
document.
section of the IX5000 and IX5200
IX5000 and IX5200 First-Time