Jnp10K-Pwr-Dc Power Supply - Juniper MX10008 Hardware Manual

Table 14: Power Input and Output Voltages for JNP10K-PWR-AC2 Power Supplies (continued)
INP0 (Switch 1) INP1 (Switch 2)
On Off
Off On
On Off
Off On
The JNP10K-PWR-AC2 requires the enhanced power bus to operate at full power. You can use the standard
bus, but available power is 3000 W for power budget from the power management software. To determine
whether your system has the standard power bus or the enhanced power bus, see
LEDs" on page 39.

JNP10K-PWR-DC Power Supply

MX10008 routers support three types of DC power supply modules:
JNP10K-PWR-DC—A 2500-W, 12-VDC dual power supply.
JNP10K-PWR-DC2—A 5500-W, 12-VDC quad input power supply. For details on this power supply,
see "JNP10K-PWR-DC2 Power Supply" on page
JNP10K-PWR-AC2—An AC, high-voltage alternating current (HVAC,) or high-voltage direct current
(HVDC) power supply. In high power mode, this power supply provides 12.3 V, 5000 W with a single
feed and 5500 W with dual feeds. For details on this power supply, see
Supply" on page 63.
All three power supplies fit into a power slot bay, but the JNP10K-PWR-AC2 and JNP10K-PWR-DC2 are
longer and protrude from the bay when fully inserted into the chassis. See
H/L (High Input 30 A/Low Input
20A)
On (30 A)
On (30 A)
Off (20 A)
Off (20 A)
68.
Output Power
5000 W
5000 W
2700 W
2700 W
"MX10008 Status Panel
"JNP10K-PWR-AC2 Power
Figure 30 on page 66.
65