Install Dc Power Supplies - Juniper PTX10016 Quick Start Manual

Install DC Power Supplies

Copyright © 2018, Juniper Networks, Inc.
Figure 19: Power Cord and Retainer Clip
1— Enable router for INP1
WARNING: Ensure that the power cords do not block access to router
components or drape where people can trip on them.
If the AC power source outlets have a power switch, set them to the on (
16.
Move the enable switches for input 1 and input 2 to the
17.
Verify that the and
18. INP1
steadily.
Press the power switch to the on (
19.
PTX10016 power supplies are hot-insertable and are field-replaceable units (FRUs). You
can install up to 10 power supplies in a PTX10016. The power supplies install in the rear
of the chassis in the slots provided along the left side.
CAUTION: Do not mix AC and DC power supplies in the same chassis.
Before you install a DC power supply in the chassis, ensure that you have followed all
1.
safety warnings and cautions:
WARNING: Before performing DC power procedures, ensure that power
is removed from the DC circuit. To ensure that all power is off, locate the
circuit breaker on the panel board that services the DC circuit, switch the
2— Enable router for
LEDs on the power supply faceplate are lit and are on
INP2
) position.
|
Install DC Power Supplies
INP2
) position.
|
position.
ON
23