Table of Contents
Advertisement
Related information
Shake task parameters
About this topic
Parameter descriptions
Bravo Platform User Guide
For information about...
Opening Diagnostics
Editing the labware classes, liquid
library, or pipetting techniques
Setting up an autofilling location
Performing a diagnostic task
Reporting a problem
The Shake task instructs the Orbital Shaking Station to shake. This topic describes
the task parameters.
To run the Shake task, see
The Shake task contains the following parameters.
Parameter
Mode
RPM
Direction
Time for operation in Timed
mode (s)
See...
"Opening Bravo Diagnostics" on page 24
VWorks Automation Control Setup Guide
"Workflow to set up an autofilling station"
on page 177
"Performing a task using Bravo Diagnostics"
on page 100
"Reporting problems" on page 87
"Performing a task using Bravo Diagnostics" on page
Description
The action of the task:
•
On. Turns on the Orbital Shaking Station.
•
Off. Turns off the Orbital Shaking Station.
•
Timed. Turns on the shaking timer. You must
specify the length of time to shake.
The shake speed, in revolutions per minute.
The direction to shake. Select one of the direction
combinations: NWSE, NESW, NS, EW, NW/SE, NE/
SW.
The length of time, in seconds, you want to leave
the shaking on. At the end of the period, the
shaking will turn off.
E Diagnostics quick reference
Shake task parameters
100.
259
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
