Agilent Technologies Bravo Platform User Manual page 205

C Setting up the Barcode Reader
Testing and optimizing barcode scanning
Adjusting the scan angle
194
Figure
Microscan Barcode Reader Diagnostics Controls tab
5
Click Scan. The barcode reader laser turns on briefly to scan the barcode label. One
of the following messages appears next to Result:
Scan result message
<barcode text>
No barcode found
6
If the No barcode found message appears, click Scan again, and check that the
barcode reader laser beam is projected onto the vertical center of the barcode label.
If the laser beam is not at the vertical center of the label, adjust the scan angle of
the Barcode Reader mirror.
7
To optimize the scanner settings, click Calibrate.
Note: During the calibration process, the scanner attempts various settings to
determine the optimum decode rate for the given conditions.
To adjust the scan angle of the Barcode Reader:
1
Loosen the screws on both sides of the Barcode Reader mirror.
Description
The barcode was
successfully scanned.
Barcode scanning was not
successful.
Next step
The setup is
complete. No further
adjustment is
required.
Proceed to step 6.
Bravo Platform User Guide