Configuring An Autofilling Station For The Bravo Platform - Agilent Technologies Bravo Platform User Manual

Workflow to set up an autofilling station
Related information

Configuring an autofilling station for the Bravo Platform

About this topic
IMPORTANT
Configuring the autofilling function
Bravo Platform User Guide
Step Procedure
1 If applicable, install the Weigh Station.
2 Install the Pump Module and reservoir.
3 In Diagnostics, configure the autofilling
function.
4 If applicable, calibrate the Weigh Station.
5 If applicable, verify the teachpoint
accuracy for the Weigh Station.
For information about...
Other Bravo accessories
Bravo Barcode Reader
Using an accessory in a protocol
An autofilling station consists of a Pump Module and an autofilling reservoir or wash
station. This topic describes how to configure a basic autofilling location.
Connect the Pump Module, Weigh Station, and an Agilent autofilling type reservoir.
For details on how to install a basic autofilling station, see the
Guide.
If you are installing an autofilling station on an AssayMAP Bravo Platform, see the
AssayMAP Bravo Platform Installation
To configure an autofilling station:
1
In Diagnostics, click the Profiles tab, and select the profile that you want to change.
2
In the Configuration tab, select the location in the Location list, or click the location
in the graphic display.
Configuring an autofilling station for the Bravo Platform
See...
Pump Module User Guide
Pump Module User Guide
"Configuring an autofilling
station for the Bravo Platform"
on page 177
"Calibrating a Weigh Station" on
page 182
"Setting teachpoints" on page 34
See...
"Accessories and platepads" on page 103
"Setting up the Barcode Reader" on page 185
VWorks Automation Control User Guide
Guide.
B Autofilling accessories
Pump Module User
177