Agilent Technologies Bravo Platform User Manual page 253

E Diagnostics quick reference
Profiles tab quick reference
Head Information area
242
Control
This is a Bravo SRT
The Head Information area contains the following controls.
Control
Head type
Change head
Teaching tip type
Check head type on
initialize
Description
Bravo SRT model only. Specifies that this Bravo
device is the SRT model, which is shorter than the
standard model.
If you are using 250-µL tips on the SRT model, select
this check box, configure the tip box location, and
install the special SRT platepad for 250-µL tip boxes
to ensure greater z-axis clearance and prevent
potential hardware crashes. See
Setting up an LT tip box location" on page
Description
Specifies the liquid-handling head type for the profile.
Starts the Change head wizard, which positions the
liquid-handling head for easy access and provides
prompts that step you through a procedure.
IMPORTANT
If you are changing the currently
installed liquid-handling head for the same type of
head and want to edit the profile, you may use the
Change head wizard. Otherwise, see
Bravo head" on page 63.
The Change head button is available only after you
initialize a Bravo profile.
Specifies the type of pipette tip to use for setting the
teachpoints.
If you change the Teaching tip type in a profile, you
must reteach the deck locations using the new tip
type.
Verifies that the liquid-handling head specified in the
profile matches the head mounted on the Bravo
Platform when the profile is used by a protocol.
CAUTION
If this check box is cleared, the Bravo
Platform will run with any liquid-handling head
installed. Therefore, if the profile specifies a 96-
channel head type, but a 384-channel head is
installed, the head will crash.
Note: If this check box is cleared, the w-axis controls
in the Jog/Teach tab will be disabled even when the
device is initialized.
"(Bravo SRT only)
172.
"Changing the
Bravo Platform User Guide