Agilent Technologies Bravo Platform User Manual page 137

A Accessories and platepads
Installing and setting up a Vacuum Filtration Station
IMPORTANT
126
10
Configure the com port for the Vacuum Filtration Station and other settings in
Bravo Diagnostics. For instructions, see
in Bravo Diagnostics" on page
To configure the controller communication settings for the pump:
1
At the controller panel, locate the power button (1) and the selection knob (2), as the
following figure shows.
CVC 3000
2
1
In the following steps, the display will reset after 20 seconds of inactivity. If this
happens, repeat the steps to access the configuration display and make the selections.
2
If the controller power is off, press the power button to turn on the display.
Note: The controller display will turn on automatically if the controller power
button was already set to on.
3
Access the controller configuration display as follows:
a
Press the selection knob to display the settings menu. Turn the knob to move
the selector to Configuration, and then press the knob to make the selection.
b
In the Configuration display, turn the knob to move the selector to RS-232, and
then press the knob to make the selection.
c
In the RS-232 configuration display, ensure that the parameters are set as
follows:
RS-232 parameters
Baud
Parity
Handshake
Remote
To change a value, turn the selection knob to the desired parameter, press the
knob to access the value, and then turn the knob to change the value. Press the
knob again to confirm the new setting.
d
Use the selection knob to move the selection to Back, and press the knob to exit
each display until you exit the Configuration display.
4
Ensure that the controller displays Vac control.
"Configuring the Vacuum Filtration Station
128.
Values
9600
8-N-1
None
Off
Note: Later, after you initialize the Vacuum Filtration
Station in your automation software, the Remote
setting will change to On automatically.
Bravo Platform User Guide