Table of Contents
Advertisement
Related information
Setting up thermal and shaking stations (Inheco controller)
About this topic
Bravo Platform User Guide
Figure
MTC Controller (front and back views)
After installing the accessory, you configure it in the Bravo profile, establish
communication, and set the teachpoint for the location.
For information about...
Configuring and teaching the Heating
Shaking Station
Using the accessory in a protocol
This topic describes how to configure the Bravo thermal and thermal shaking
accessories that are controlled by the Inheco Single TEC Controller (STC) or Multi TEC
Controller (MTC). The Inheco STC and MTC controlled accessories include the
following:
Accessory name
Peltier Thermal Station
Heating Shaking Station
The STC can control a single Inheco device, and the MTC can control multiple Inheco
devices. For a detailed description of the Inheco STC or MTC, see the Inheco STC or
MTC user documentation.
Setting up thermal and shaking stations (Inheco controller)
See...
"Setting up thermal and shaking stations
(Inheco controller)" on page 159
VWorks Automation Control User Guide
A Accessories and platepads
Corresponding Inheco name
CPAC Ultraflat
Teleshake 95
159
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
