Installing And Configuring A Magnetic Bead Accessory - Agilent Technologies Bravo Platform User Manual

Installing and configuring a Magnetic Bead Accessory

About this topic
WAR NIN G
Before you start
Preparing the Magnetic Bead Accessory for installation
Bravo Platform User Guide
This topic describes how to set up the Magnetic Bead Accessory on a standard
platepad.
Figure
Magnetic Bead Accessory
To avoid potential injury and damage to the device, only personnel trained in how to
set up Magnetic Bead Accessory and teach the Bravo Platform should perform the
following procedures.
Make sure you have the following:
•
Magnetic Bead Accessory
•
1.5 mm hex wrench
•
Standard platepad installed at the target deck location
Use the following workflow.
Step For this task...
1 Prepare the accessory for installation.
2 Configure the accessory in the profile.
3 Teach the accessory location.
To prepare the Magnetic Bead Accessory:
1
Place the Magnetic Bead Accessory on a flat surface, and press down on the top of
the magnet and then release it to determine if the springs have been removed.
•
If the magnet does not spring back up after release, skip to step 3.
Installing and configuring a Magnetic Bead Accessory
See...
"Preparing the Magnetic Bead
Accessory for installation" on
page 143
"Configuring the accessory in Bravo
Diagnostics" on page 144
"Teaching the Magnetic Bead
Accessory" on page 145
A Accessories and platepads
143