Agilent Technologies Bravo Platform User Manual page 192

Related information
Bravo Platform User Guide
Control
Fill pump
Fill direction
Pump fill speed
(0–100%)
Empty module
Empty pump
Empty direction
Pump empty speed
(0–100%)
Run pumps
Stop pumps
4
Click Run pumps and verify that the pump is functioning properly.
5
Click Stop pumps, and then click OK.
For information about...
Starting up and shutting down the
Bravo Platform
Installing a Pump Module
Calibrating a Weigh Station
Draining or filling a reservoir using the
Pump Reagent process
Setting up liquid and labware
definitions
Using an accessory in a protocol
Configuring an autofilling station for the Bravo Platform
Description
Specifies which of the two pumps on the Pump Module
to use for filling the container, where
1 controls the upper pump.
2 controls the lower pump.
Forward. Moves the pumped fluid in the forward
direction of the pump.
Reverse. Moves the fluid in the opposite direction.
Specifies how quickly the pump moves the fluid, where
100% is the fastest setting.
Specifies the Pump Module that this deck location
uses. One Pump Module can function as both the Fill
module and Empty module. For example, select 1 if
only one Pump Module is connected.
Specifies which of the two pumps on the Pump Module
to use for emptying the container, where
1 controls the upper pump.
2 controls the lower pump.
Forward. Moves the pumped fluid in the forward
direction of the pump.
Reverse. Moves the fluid in the opposite direction.
Specifies how quickly the pump moves the fluid, where
100% is the fastest setting.
Starts the pumps on the selected Pump Module in real
time.
Stops the pumps in real time.
See...
"Starting up and shutting down" on page 17
Pump Module User Guide
"Setting up a Weigh Station" on page 182
"Performing a task using Bravo Diagnostics"
on page 100
VWorks Automation Control Setup Guide
VWorks Automation Control User Guide
B Autofilling accessories
181