Agilent Technologies Bravo Platform User Manual page 163

A Accessories and platepads
Setting up the Thermal Station (cooling pad)
Setup workflow
Installing the Thermal Station
WAR NING
152
Step Procedure
1 Install the Thermal Station at the Bravo
deck location.
2 Edit the teachpoint.
Note: Earlier model thermal pads may not
have a crosshairs. In this case, use the
teach plate. Be sure to consider the
10-mm thickness of the teach plate when
you edit the teachpoint.
3 Complete the hardware setup.
Before you start
Make sure you have the following:
•
Thermal Station (cooling pad), including the adapter pad and socket-head screw
that fastens the adapter pad to the deck
•
Hex wrenches: M1.5, M2, and M5
•
Plumber's tape
•
Liquid chilling unit, tubing, and manufacturer user documentation
To prevent a potential injury, turn off the Bravo Platform before you install or remove
the accessory.
Procedure
To install the Thermal Station:
1
Ensure that the platepad is removed from the target deck location.
To remove the platepad, uninstall the M6 screw in the center of the platepad and
then lift the platepad off of the deck.
2
Prepare the aluminum adapter pad, as follows:
a
Install the elbow plug (part G5550-24200) with plumber's tape in the drain hole
on the adapter pad.
b
Set the plug angle slightly lower than parallel to the pad to allow draining.
See...
"Installing the Thermal Station"
on page 152
"Setting the first teachpoint" on
page 36
"Completing the hardware
setup" on page 154
Bravo Platform User Guide