Agilent Technologies Bravo Platform User Manual page 72

Related information
Bravo Platform User Guide
Inspection or maintenance task
Inspect moving parts to ensure
they are not rubbing against
each other.
Verify teachpoint accuracy for
each deck location. Reset the
teachpoints as required.
Pump Module. If applicable,
inspect the tubing. Change out
the tubing as necessary.
For instructions on routing the
tubing, see the Pump Module
User Guide.
Weigh Station. If applicable,
verify that the configured empty
and full weights are still valid.
See "Setting up a Weigh Station"
on page 182 for instructions on
how to configure the Weigh
Station.
For information about...
Cleaning between protocol runs
Cleaning the Bravo Platform
Setting teachpoints
Reporting a problem
4 Maintenance and troubleshooting
Routine maintenance and cleaning
Schedule Symptoms
Monthly Rub marks or noises that might
indicate rubbing
To resolve these issues, contact
Agilent Automation Solutions
Technical Support.
Every 6 Any of the following:
months, or
•
Issues when pressing on or
sooner
removing pipette tips
•
Tips that appear off-center in
the wells, or inaccurate
pipetting at specific deck
locations
•
Improper labware placement
by the gripper
Note: Issues other than
teachpoint accuracy can also
cause these symptoms. For
details, see
hardware problems" on page
Monthly Tube deterioration, or liquid fails
to pump or fails to drain properly
Bimonthly Deterioration of liquid-level
accuracy in reservoir
See...
"Cleaning up after a run" on page 62
"Routine maintenance and cleaning" on
page 60
"Setting teachpoints" on page 34
"Reporting problems" on page 87
"Troubleshooting
81.
61