Task 6-3: Defining The Call Coverage Path For Voice Ports - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
4 Initial Switch Administration: G3i/G3s/G3vs/R5vs/R5si/ProLogix
Defining the Call Coverage Path for Voice Ports
Table 4-8. Hunt Group Screen Entries — Page 2
Field
LWC Reception
First
Announcement
Extension
First
Announcement
Delay (sec)
6. Press
7. Continue with
Task 4-3: Defining the Call Coverage Path for
Voice Ports
Define a call coverage path for the voice ports using the DEFINITY AUDIX hunt
group as Coverage Point 1. The DEFINITY AUDIX voice ports cover to
themselves.
To define a call coverage path for the voice ports only:
1. At the switch terminal, enter add coverage path number , where number is
the call coverage path number assigned in Worksheet B-3.
The switch displays the Coverage Path screen.
Description
none
A recorded announcement extension number. You can
leave this field blank. This is the announcement the
caller receives after being in the queue for the time
interval specified in the First Announcement Delay field.
(See "Switch Recorded Announcement" on page 6-6
Chapter 6, "Optional Switch Feature
instructions on setting up a recorded announcement.)
This field is optional if the queue field is y and must be
left blank if there is no first announcement. Enter the
number of seconds that a call can remain in queue
before the associated first announcement is given to the
calling party.
to save the hunt group.
ENTER
NOTE:
You will add the DEFINITY AUDIX voice ports to this hunt group in
Task 4-6.
Task 4-3.
NOTE:
If you have not obtained a coverage path number, you can enter list
coverage path to find an available coverage path, or enter add
coverage path next to assign the next available hunt group number.
Issue 1
May 1999
4-14
in
Administration", for