Installation Steps - Lucent Technologies DEFINITY AUDIX Installation And Administration Manual

Installation and Switch Administration for G3i/G3s/G3vs/R5vs/R5si/ProLogix
Switches, TN2181 Emulation, Display Set Integration 585-300-122
2 Hardware Installation
Install the DEFINITY AUDIX System Assembly
20 19 18
Female
RS-232
Port C
Figure 2-2. Connecting the Adapter Cable, Rear-Panel View
If the DEFINITY AUDIX system was shipped in a new switch, verify that the
adapter cable is installed. If so, skip to Step

Installation Steps

Using Worksheet
system assembly.
1. Wear a ground wrist strap on your bare skin and connect to a ground
when handling circuit cards, disk drives, and the system board. Refer to
Task 1-3
2. Remove the amphenol connector, if any, from the second slot of the two
contiguous slots reserved for the DEFINITY AUDIX system. For example, if
you install the DEFINITY AUDIX system in slots 7 and 8 of carrier A in the
switch, remove the amphenol connector on the Group 300 cables from
slot 8. This slot provides connectivity to the DEFINITY AUDIX system
circuit pack.
3. Dress down the cable you removed.
17 16 15 14 13 12
Female Female
RS-232 RS-232
Port B Port A
NOTE:
If Definity Audix is already installed in the switch, the system will boot
up when the switch is turned on.
A-3, follow the steps below to install the DEFINITY AUDIX
for complete instructions.
Example of
DEFINITY AUDIX
slots
11 10 9 8 7 6 5
Female
RJ45
LAN
7 of this task.
Issue 1
May 1999
4 3 2 1
rcdxslim AWF 021799
Female
amphenol
Alarm relay
2-5